1
LaserBoy !!! / 2019.05.07 version issue
« on: October 19, 2019, 01:09:53 pm »
Hello James!
I wanted to report about the issue when opening dxf frameset.
If you open a frameset and then remove all the frames (using backspace) then when you press i->2->3 it opens the previous frameset again (you can't open the new one).
Thank you in advance!
I wanted to report about the issue when opening dxf frameset.
If you open a frameset and then remove all the frames (using backspace) then when you press i->2->3 it opens the previous frameset again (you can't open the new one).
Thank you in advance!